Switch2

Library

Branching

Description

The Switch block passes through the first (top) input or the third (bottom) input based on the value of the second (middle) input. The first and third inputs are called data inputs. The second input is called the control input. You select the conditions under which the first input is passed with the Criteria for passing first input parameter. You can make the block check whether the control input is greater than or equal to the threshold value, purely greater than the threshold value, or nonzero. If the control input meets the condition set in the Criteria for passing first input parameter, then the first input is passed. Otherwise, the third input is passed.

Dialog Box

Set parameters
pass first input if: u2$>$=a (0), u2$>$a (1), u2 =a (2)	0
threshold a	0
use zero crossing: yes (1), no (0)	1

• pass first input if: u2$>$=a : Select the conditions under which the first input is passed. You can make the block check whether the control input is greater than or equal to the threshold value, purely greater than the threshold value, or nonzero. If the control input meets the condition set in this parameter, then the first input is passed. Otherwise, the third input is passed.
• threshold a:Assign the switch threshold that determines which input is passed to the output.
• use zero crossing: yes : Select to enable zero crossing detection.

Default properties

• always active: no
• direct-feedthrough: yes
• zero-crossing: yes
• mode: yes
• number/sizes of inputs: 3 / -1 1 -1
• number/sizes of outputs: 1 / -1
• number/sizes of activation inputs: 0 /
• number/sizes of activation outputs: 0 /
• continuous-time state: no
• discrete-time state: no
• name of computational function: switch2

Interfacing function

scilab/macros/scicos_blocks/branching/SWITCH2.sci

Computational function (type 4)

#include "scicos_block.h"
#include <math.h>

void  switch2(scicos_block *block,int flag)
{
  int i,j,phase;
  if (flag == 1) {
    phase=get_phase_simulation();
    if (phase==1){
      i=2;
      if (*block->ipar==0){
	if (*block->inptr[1]>=*block->rpar) i=0;
      }else if (*block->ipar==1){
	if (*block->inptr[1]>*block->rpar) i=0;
      }else {
	if (*block->inptr[1]!=*block->rpar) i=0;			     
      }
    }else{
      if(block->mode[0]==1){
	i=0;
      }else if(block->mode[0]==2){
	i=2;
      }
    }
    for (j=0;j<block->insz[0];j++) {
      block->outptr[0][j]=block->inptr[i][j];
    }
  }else if(flag == 9){
    phase=get_phase_simulation();
    block->g[0]=*block->inptr[1]-(*block->rpar);
    if (phase==1){
      i=2;
      if (*block->ipar==0){
	if (block->g[0]>=0.0) i=0;
      }else if (*block->ipar==1){
	if (block->g[0]>0.0) i=0;
      }else {
	if (block->g[0]!=0.0) i=0;			     
      }
      if(i==0) {
	block->mode[0]=1;
      }else{
	block->mode[0]=2;
      }
    }
  }
}